Shaw Kennel Basic Pen 2

A basic pen is made up of 4 frames and a gate.Each frame uses 4 corner clamps. We highly recommend the gate design that is pictured, one that uses a gate frame that is at least a foot wider then the gate. This section in the frame adds a lot of strength to the gate frame when the mesh is laced in. Even if you want your pen or run to be 3 feet wide we recommend a 2 foot gate in a 3 foot frame.

Risers are used to elevate the kennel holding it above the floor so that you can use a water hose and wash out under the kennels. They should only be used on cement floors or other hard level surfaces. Use at least 2 risers per frame. (T-Support clamps can also be used as risers (if you have an unleveled floor use a pipe in the t-support clamp to adjust the height of the riser)

Double clamps are used to fasten the corners together or to fasten two frames end to end.

T-Support clamps are used to fasten a pipe at a right angle within a frame, for upright or cross support. They come in 2 sizes: 3/4 to 3/4 and 3/4 to 1/2 ( to fit 3/4" ID water pipe or 1/2" ID water pipe) They can also be used as risers (if you have an unleveled floor use a pipe in the T-Support clamp to adjust the height of the riser)

For the pen shown you need:

20--- Corner Clamps 8 ----Double Clamps 5-----T Support Clamps 8 ----Frame Risers 2 ----Hinges 2---- Hinge Rest 1---- Latch 1 ----Latch Bar 1 ----Latch Bar Bracket 1 ----T Boss

CHECK OUT OUR ONLINE DRAWINGS OF DIFFERENT KENNEL CONFIGURATIONS.